For 2000-06 Toyota Tundra 2001-07 Sequoia Power Steering Rack & Pinion 244-0097

  

High-quality replacement:Power steering rack and pinion. This part may also be known as:Power steering (PAS) or steering assist system. 100% tested For reliability and performance. Top performance For long service life.

Undergone strict tests to ensure reliable performance. Air Tested to Ensure Reliable Performance.

Hydraulically Tested to Ensure Internal By-Pass for Both High and Low Pressures. Road simulated for proper functioning. Simple installation and and long life as a guarantee.

Backed by satisfying after-sales service. Best choice of motor parts.

2001 - 2007 For TOYOTA Sequoia Power Steering - All Models 2000 - 2006 For TOYOTA Tundra Power Steering - All Models. How to Replace a Power Steering Rack.

Drain the power steering fluid, loosen the front wheel nuts and jack up the car. Once the vehicle is properly supported on the jack stands, remove the front wheel lug nuts and the wheels. Disconnect the tie rods Detach the clamps connecting the steering column to the piston.

Disconnect the outer rod ends using a special tie rod separator or ball joint fork. Loosen the nuts and turn the rods. Remove the faulty steering rack Insert a drainage pan under the car to catch any fluid and unbolt the power steering rack from its seating.

Remove the rack via one of the wheel wells. Use plenty of effort, patience and ingenuity.

Install the new power steering rack Using the same exit point as your entry point, insert the replacement rack into position using the required force. Measure the length of the old rack to determine the precise positions of the tie and cotter pins.

Insert the pins in the new rack. Reattach the hoses, except the steering fluid reservoir return line. Replace the components that were removed to enable access to the rack, together with the front wheels.

Bleed the power steering system Start the car. Turn the steering wheel back and forth for about 15 minutes to release air trapped in the system.

Turn off the engine and let it stand before topping up the reservoir with fluid. If the fluid is light brown in colour or has foam on the top, repeat the process until the fluid is clear. Reattach the reservoir hose, remove the drainage pan, lower the car and tighten the wheel nuts. We specialize in automotive car parts and is the No. 1 industry distributor for afFor Fordable and quality products.

You can tell by our feedback that we've been doing this for many years and have the expertise to accommodate your every needs. Some of the packages cannot be delivered to a PO Box. Package will be held until a valid physical address is provided. We are not responsible for carrier transit time. This information is provided by the carrier and excludes weekends and holidays.

And the city of destination. With your support, we will make a progress everyday, we always grow up with you. Radiator For Ford Fusion 2013 2014 2015 2016 2017 2018 2019 2020 1.5L 2.5L. Radiator for 09-10 For Ford F150 4.6L 5.4L 6.2L / 09-14 Expedition For Lincoln Navigato.