For BMW 325i 323i 328i 330i 325Ci 330Ci E46 26-2800 Power Steering Rack & Pinion

  

Steering gear, also called steering gear, is the most important part of automobile steering system. Power steering (PAS) or steering assist system helps drivers steer by augmenting steering effort of the steering wheel.

Power steering rack and pinion is the most important part for vehicle swerving and security assurance. It converts the rotational motion of the steering wheel into the linear motion needed to turn the wheels and provides a gear reduction, thus making it easier to turn the wheels.

18000076-101, 18000076-102, 18000076-103, 18000076-104, 18000076-105, 26-2800, 32 13 1 097 315. Power Steering - Sedan Models With ZF Style Rack and Pinion. Power Steering - Coupe and Convertible Models.

Power Steering - All Models. Power Steering - Sedan With ZF Style Rack and Pinion.

Power Steering - 325i Models - WIth ZF Style Rack. Power Steering - 325Ci Models - With ZF Style Rack. Power Steering - With ZF Rack. Power Steering - With ZF Style Rack.

Power Steering - Sedan With ZF Style Rack. Power Steering - 330i Models - With ZF Style Rack. Power Steering - 330Ci Models - With ZF Style Rack. High-quality replacement:Power steering rack and pinion. This part may also be known as:Power steering (PAS) or steering assist system.

100% tested For reliability and performance. Top performance For long service life. Undergone strict tests to ensure reliable performance. Air Tested to Ensure Reliable Performance. Hydraulically Tested to Ensure Internal By-Pass for Both High and Low Pressures.

Road simulated for proper functioning. Simple installation and and long life as a guarantee. Backed by satisfying after-sales service. How to Replace a Power Steering Rack. Drain the power steering fluid, loosen the front wheel nuts and jack up the car. Once the vehicle is properly supported on the jack stands, remove the front wheel lug nuts and the wheels. Detach the clamps connecting the steering column to the piston. Disconnect the outer rod ends using a special tie rod separator or ball joint fork.

Loosen the nuts and turn the rods. Remove the faulty steering rack. Insert a drainage pan under the car to catch any fluid and unbolt the power steering rack from its seating.

Remove the rack via one of the wheel wells. Use plenty of effort, patience and ingenuity. Install the new power steering rack. Using the same exit point as your entry point, insert the replacement rack into position using the required force.

Measure the length of the old rack to determine the precise positions of the tie and cotter pins. Insert the pins in the new rack. Reattach the hoses, except the steering fluid reservoir return line. Replace the components that were removed to enable access to the rack, together with the front wheels. Bleed the power steering system.

Turn the steering wheel back and forth for about 15 minutes to release air trapped in the system. Turn off the engine and let it stand before topping up the reservoir with fluid. If the fluid is light brown in colour or has foam on the top, repeat the process until the fluid is clear.

Reattach the reservoir hose, remove the drainage pan, lower the car and tighten the wheel nuts. Rule B: outer package without any damage. In the condition o the below reasons. We will strive to providing the greatest service and bringing the highest satisfaction to all of our customers.