Power Steering Rack And Pinion For 2001-2004 Chrysler Sebring & Dodge Stratus

  

Steering gear, also called steering gear, is the most important part of automobile steering system. Power steering (PAS) or steering assist system helps drivers steer by augmenting steering effort of the steering wheel. Power steering rack and pinion is the most important part for vehicle swerving and security assurance.

It converts the rotational motion of the steering wheel into the linear motion needed to turn the wheels and provides a gear reduction. Thus making it easier to turn the wheels. In order to ensure the normal operation of the steering gear, relevant parts shall be cleaned as much as possible before installation. In order to avoid the fault caused by the dirt entering the steering oil circuit, the plug on each oil port of steering pump of steering gear shall be opened before connecting the oil pipe, and the oil pipe and plug shall be carefully cleaned and deburred. Turn the steering wheel to the straight ahead position.

Clean the mounting bracket of the steering gear and relevant mating surfaces of the steering gear. For the adjustable steering column, use a suitable rope to pass through the space of the cross fork of the steering shaft, hang the steering shaft, and connect the steering shaft and the input shaft of the steering gear. Turn the steering gear to the middle position to align the relevant marks at the input end and output end of the steering gear.

Install the steering gear on the mounting base and tighten the fixing bolts. Universal joint or coupling between mounting column and steering gear. For the adjustable steering column, the upper end seal of the steering gear shall not be damaged when the universal joint is installed.

Keep the steering wheel in straight ahead position. Put the pitman arm on the steering gear to align the two marks. Tighten the locknut according to the specified torque and rivet (anti loose pit).

Three stars is LOW star, NO 1,2,3 stars PLEASE!